fxs-fxo

This command configures FXS and FXO interfaces.

Syntax

(config-voip)# interface fxs-fxo
(fxs-fxo)#

Command

Description

analog-port-enable

Enables the analog port.

bellcore-callerid-type-one-sub-standard

Selects the sub-standard of the Bellcore Caller ID type.

bellcore-vmwi-type-one-standard

Defines the Bellcore VMWI standard.

caller-id-timing-mode

Defines the Analog Caller ID Timing Mode.

caller-id-type

Defines the Caller ID standard.

current-disconnect-duration

Defines the current-disconnect duration (in msec).

default-linepolarity-state

Sets the default line polarity state.

disable-analog-auto-calibration

Determines whether to enable the analog Autocalibration in the DAA.

enable-analog-dc-remover

Determines whether to enable the analog DC remover in the DAA.

enable-fxo-current-limit

Enables loop current limit to a maximum of 60mA (TBR21) or disables the FXO line current limit.

etsi-callerid-type-one-sub-standard

Selects the number denoting the ETSI CallerID Type 1 sub-standard.

etsi-vmwi-type-one-standard

Selects the number denoting the ETSI VMWI Type 1 Standard.

far-end-disconnect-type

Sets the source for the acEV_FAR_END_DISCONNECTED event.

flash-hook-period

Defines the flashhook detection and generation period (in msec).

fxo-country-coefficients

Line characteristic (AC and DC) according to country.

fxo-dc-termination

Defines the FXO line DC termination.

fxs-country-coefficients

Defines the line characteristic (AC and DC) according to country.

fxs-line-testing <Module/Port> {66|70}

Performs an FXS line test for a specified FXS port and coefficient type (66 for TBR21 and 70 for USA).

fxs-rx-gain-control

Defines gain\attenuation of the FXS Rx path between -17db and 18db.

fxs-tx-gain-control

Defines gain\attenuation of the FXS Tx path between -22db and 10db.

metering-on-time

Defines the metering signal duration to be detected

metering-type

Defines the metering method for charging pulses.

min-flash-hook-time

Defines the minimal time (in msec) for detection of a flash hook event (for FXS only).

mwi-indication-type

Defines the type of (MWI) Message Waiting Indicator (for FXS only).

polarity-reversal-type

Defines type of polarity reversal signal used for network far-end answer and disconnect indications.

rx-gain-control

Defines gain attenuation of the FXO Rx path between -15db and 12db.

time-to-sample-analog-line-voltage

Defines the time to sample the analog line voltage after offhook, for the current disconnect threshold.

tx-gain-control

Defines gain attenuation of the FXO Tx path between -15db and 12db.

wink-time

Defines time elapsed between two consecutive polarity reversals.

Command Mode

Privileged User

Example

This example enables FXS port 1 in Module 2:

(config-voip)# interface fxs-fxo 
(fxs-fxo)# analog-port-enable 1/2
(fxs-fxo)# activate